Permofloor Solvent-Based Floor Paint

Permofloor Solvent-Based Floor Paint

Permolit Permofloor Solvent-Based Floor Paint is an MMA thermoplastic resin-based, fast-drying, single-component floor coating designed for interior and exterior surfaces. Its semi-matte finish provides decorative appearance and durable protection in areas exposed to light vehicle and heavy pedestrian traffic.

High adhesion and mechanical resistance

Suitable for concrete, asphalt, screed and stone surfaces

Resistant to water, UV rays and abrasion

Fast drying and quick traffic opening

Easy to clean, stain resistant surface

PERMOLIT PERMOFLOOR Solvent-Based Floor Paint

PERMOLIT PERMOFLOOR is a solvent-based, MMA thermoplastic resin-based, fast-drying, ready-to-use, high-performance, single-component floor paint. With its semi-matte finish, it provides both decorative appearance and long-lasting surface protection for interior and exterior floors.

Field of Application

The product is suitable for use on various mineral and stone-based surfaces in areas exposed to light vehicle and heavy pedestrian traffic.

Asphalt, concrete, screed, polished concrete
Paving stones, curb stones, paving tiles
Schools, residential buildings and housing complexes
Offices, shopping malls and retail stores
Garages and parking areas
Bicycle paths and walking paths
Warehouses and similar facilities

Features

Aesthetic semi-matte appearance
Long-lasting surface protection
Resistant to friction, impact and abrasion
Resistant to water and salt water
Provides waterproofing by filling capillary cracks on the surface
Fast drying
Easy to clean and stain resistant
Resistant to rain, snow, sunlight and UV rays
Resistant to chemical cleaning agents
Ready to use, easy to apply and quick curing
Available in standard colours; RAL K7 colours available on special order

Application Instructions

Surface Preparation

Surfaces must be free from dirt, dust, grease, old paint residues and loose materials that cannot support themselves. Blistered or damaged areas should be removed down to solid substrate. Surface irregularities and cracks must be repaired using epoxy repair putty or cement-based repair mortars. The surface must be completely dry before application.

Application Method

After thoroughly mixing, apply the product in two coats using a brush, roller or spray without thinning. Allow 2–4 hours between coats. Application tools should be cleaned immediately after use with industrial thinner.

Thinning

Ready to use.
If required, thin up to 5% for brush and roller applications.
Thin up to 10% for spray applications.
Use industrial or rapid thinner.

Technical Information

Flash Point	≥ 23°C
Coverage	3 – 4 m²/L for two coats (0.300 – 0.400 g/m²)
Application Tools	Synthetic epoxy roller, brush or airless spray
Drying Time	Touch dry: ~30 minutes \| Full dry: 24 hours
Traffic Opening	Pedestrian and vehicle traffic after 24 hours
Full Performance	After 7 days

Packaging

15 L
2.5 L

Storage Conditions

The product can be stored for up to 2 years in its unopened packaging, on pallets, in a cool and dry place, protected from direct sunlight and frost. Maximum stacking: 5 units for 15 L packaging and 7 units for 2.5 L packaging.

Warnings and Safety Information

Hazard Statements

H226: Flammable liquid and vapour.
H315: Causes skin irritation.

Precautionary Statements

P102: Keep out of reach of children.
P210: Keep away from heat, sparks, open flames and hot surfaces. Do not smoke.
P261: Avoid breathing dust, fumes, gas, mist, vapours or spray.
P280: Wear protective gloves, clothing, eye and face protection.
P302+P352: IF ON SKIN: Wash with plenty of water.
P501: Dispose of contents/container in accordance with applicable waste regulations.